, Guest!
Already a Member? Login or Register.



Main Menu



RVDR Club Form



eNews

To subscribe to our newsletter, please enter your email address in the box below and click the "Subscribe" button.


Note:  You may easily remove yourself from the newsletter list at any time by following the instructions included with every mailing.


Guest Book
Home > Forum > River Valley Dirt Riders Forum > Tech Tips > Need cylinder bored - local shop?

Forum


Need cylinder bored - local shop?
Started March 4, 2008 @ 4:08pm by Alan
 Post Message 
Alan


Posts: 17
 
Need cylinder bored - local shop?March 4, 2008 @ 4:08pm
Well, the used Grizzly 660 that I bought a while back is using a little bit more oil than I like, so I'm looking at tearing into it and doing a top-end rebuild. While I've got it apart, I'm probably going to drop in a 11:1 Wiseco piston (stock compression is 9.1:1) and port the head. The question I have is, assuming that I need to clean up the cylinder by over-boring it one size up to 100.5mm, is there a Russellville area machine shop that can do a top quality bore/hone job on this ~4" cast iron liner cylinder? If not in the Russellville area, where is the best shop to do this type of work within ~1 hour drive?
 

Post Message 

News, Weather & Search

News:
CNN
Google News
BBC News
CBC News

Weather:



Search:
Google




©2006-2008 River Valley Dirt Riders (Off Roaders). All Rights Reserved.


Powered By FlexCMS